D1265 | Installation Guide | 4.0 RPS Configuration
.
Bosch Security Systems, Inc. | 11/11 | F01U169129-05 7
3.2.3 Adjust the Display Brightness
To adjust the keypad’s display brightness, press the Up
or Down arrow buttons until you reach the desired
level (1 = darkest; 15 = brightest).
3.2.4 Screen On Time
To adjust how long the keypad display stays on, press
the Up or Down arrow buttons until you reach the
desired time (1-15 min).
If there is no keypad activity within the specified
duration, the keypad goes into sleep mode. In this
mode, the keypad display is dark.
3.3 Saving Changes and Exiting the
Setup Menu
When you are done making changes in the setup
menu, press the Save button. To exit the setup menu,
press the Back button. The keypad returns to the
normal display.
4.0 RPS Configuration
To configure the D1265, RPS version 5.12
or later is required.
4.1 Start RPS
For complete instructions on using RPS to program a
control panel, refer to the RPS Online Help and the
specific control panel’s online help file in RPS.
1. Start RPS.
2. Enter a valid username and password.
3. Open the desired control panel account.
4.2 Enable the Keypad
1. In the Program Record Sheet, locate the section
called COMMAND CENTER (GV2MAIN). This
section is named the same whether you are in a
GV3 or a GV2 account.
Figure 8: RPS: COMMAND CENTER (GV2MAIN)
2. In the Cmd Ctr Assignments pane, locate
Enhanced Command Center.
Figure 9: RPS: Enhanced Command Center
3. Change Enhanced Command Center for the
desired keypad address to Yes.
Figure 8 uses CC Address 1 as an example.
To Next Page
Loading...
