Bosch D4412 - Telephone Connections

D6412/D4412 Operation and Installation Guide
D6412/D4412
Page 23© 2003 Bosch Security Systems 45349E
6.0 Telephone Connections
6.1 Registration
The Bosch Security Systems D6412/D4412 Control Panel is registered with the Federal Communication Commission (FCC)
under Part 68 for connection to the public telephone system using an RJ31X or RJ38X jack installed by your local phone
company.
6.2 Notification
Do not connect registered equipment to party lines or coin-operated telephones. You must notify the local telephone
company and supply them with the following information before connecting the panel to the telephone network.
• Line to which you are connecting the panel
• Make (Bosch Security Systems), model (D6412 or D4412), and serial number of the panel
• FCC registration number: ESVMUL-46531-AL-E
• Ringer equivalence for the panel: 0.1 B
6.3 Location
To prevent jamming of signals, wire the RJ31X jack or RJ38X jack to support line seizure as shown in Figure 6. Install the jack
on the street side of the phone switch, wired ahead of any PBX equipment. Line seizure temporarily interrupts normal phone
usage while the communicator transmits data. After installation, confirm that the panel seizes the line, acquires dial tone,
reports correctly to the receiver, and releases the phone line to the in-house phone system.
1 2 3 6 7 8
1 2 3 4 5 6 7 8
R1 T1R T
RJ31X Jack
Telco Connector Block
Outside Telco
(PSTN)
4 5
Premises
Telephone
T
R
T1
R1
To Control Panel
Bar Short removed on
Telco Connector Block
insertion - positions
1&4 and 5&8.
RJ31X Jack Connections
1 2 3 6 7 8
1 2 3 4 5 6 7 8
R1 T1R T
RJ38X Jack
Telco Connector Block
Outside Telco
(PSTN)
4 5
Premises
Telephone
T
R
T1
R1
To Control Panel
Bar Short removed on
Telco Connector Block
insertion - positions
1&4 and 5&8.
RJ38X Jack Connections
Strap
Figure 6: RJ31X/RJ38X Wiring
6.4 Phone Cord Connection
Connect the flying leads of a D164 Telephone Cord to the telephone terminals labeled R, R1, T1, and T. The terminals are
located on the right side of the panel. Connect the other end of the cord to the RJ31X jack or RJ38X jack.
6.5 System Status LED (Red)
The System Status LED shows system status, including phone status as described in Table 4. Figure 4 shows the location of
the LED on the panel.
6.6 Dialing Format
You can program the system to use DTMF or pulse dialing. See DTMF/Pulse Dialing in the D6412/D4412 Program Entry
Guide (P/N: 45351).
Telephone Connections