D9412GV4/D7412GV4 v2.03 | Installation and System Reference Guide | 18.0 Installer Menu
.
Bosch Security Systems, Inc. | 7/16 | F01U265457-09 110
Enhanced Comm Parms
B91x/B92x keypads Configuration of Enhanced Comm Parms
1. Enter the installer passcode, and then go to the [1] Installer menu.
2. Go to the [1] Program > [1] Reporting > [2] Network > [2] Enhanced Comm Parms menu
option. The keypad displays the Enhanced Comm Parms option.
3. Press [ENTER] to edit the enhanced comm parms option. The options scroll through in
succession.
4. Use the [PREV] and [NEXT] buttons to toggle between the address, port #, poll rate, and
encryption options.
5. Press [ENTER] to edit the desired parameter.
6. When the keypad shows Parameter Saved, escape from the menu.
B93x/B94x keypads Configuration of Enhanced Comm Parms
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to the [1] Program > [1] Reporting > [2] Network > [2] Enhanced Comm Parms menu
option. The keypad displays the enhanced comm parms option as well as the current default
value.
3. Press the softkey for the desired option (Address, Port #, Poll Rate, or Encryption).
4. Press the Edit softkey to change programming.
5. Press the Save softkey.
6. When the keypad shows Parameter Saved, escape from the menu.
Address
B91x/B92x keypads Configuration of Address
1. Enter the installer passcode, and then go to the [1] Installer menu.
2. Go to the [1] Program > [1] Reporting > [2] Network > [2] Enhanced Comm Parms menu
option. The keypad displays the Enhanced Comm Parms option.
3. Press [ENTER] to edit the enhanced comm parms option. The options scroll through in
succession.
4. Use the [PREV] and [NEXT] buttons to toggle between the address, port #, poll rate, and
encryption options.
5. Press [ENTER] to edit the Address parameter.
6. When the keypad shows Parameter Saved, escape from the menu.
B93x/B94x keypads Configuration of Address
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to the [1] Program > [1] Reporting > [2] Network > [2] Enhanced Comm Parms menu
option. The keypad displays the enhanced comm parms option as well as the current default
value.
3. Press the softkey for the Address option.
4. Use /[PREV] or /[NEXT] to go to the path you wish to edit.
5. Press the Edit softkey to change programming.
6. Press the Save softkey.
7. When the keypad shows Parameter Saved, escape from the menu.
To Next Page
Loading...
