D8125
D8125 Operation and Installation Guide
Page 33© 2004 Bosch Security Systems, Inc. 74-04247-000-N
3.3.6 POPIT Displays
The status of each POPIT Module is transmitted to the D8112G1/G2 Control Panel. The status is recorded and held in the
D8112G1/G2 memory buffer until the system is armed and the exit delay time has expired. The D1252A Command Center
displays both the current status and the event memory with a special code.
3.3.6.1 Alarm Condition Displays
When an event occurs in the system
(an open or shorted loop) that the
D8112G1/G2 interprets as an alarm,
the system initiates an alarm
response, and the D1252A sequences
through the following displays:
3.3.6.2 Fault Condition Displays
When a loop fault occurs, the
following displays can appear on the
D1252A (rows of stars separate
displays pertaining to individual
points of protection):
3.3.6.3 Trouble Condition Displays
When a loop trouble occurs, the
following displays can appear on the
D1252A (rows of stars separate
displays pertaining to individual
points of protection):
Installation
SERVICE WINDOWS
Programmed
display* (8112:MAIN)
Standard
display indicating a troubled zone.
ZN301S2 KITCHEN
Programmed
display* (8112:PTEXT)
Standard
POPIT status code for POPIT #301
**************
(Row of stars)
NOT READY TO ARM
Standard
display indicating an abnormal loop condition
* This programmed display will appear for all points on this master zone.
FAULTED DOORS
Programmed
display* (8112:MAIN)
display indicating a faulted
condition exists on this zone.
ZN204O FRONT
Programmed
display* (8112:PTEXT)
Standard
POPIT status code for POPIT #204
**************
(Row of stars)
* This programmed display will appear for all points on this master zone.
Programmed
display* (8112:MAIN)
Standard
D8112 alarm display.
ZN102S1 RISER#2
Programmed
display* (8112:TEXT)
Standard
POPIT status code for POPIT #102
**************
(Row of stars)
* This programmed display will appear for all points on this master zone.
To Next Page
Loading...
