Bosch D8125 - Figure 18: Extra POPIT Installed; Figure 19: POPIT Switch Setting Error

D8125 Operation and Installation Guide
D8125
Page 38 © 2004 Bosch Security Systems, Inc.74-04247-000-N
Installation
If an extra POPIT is installed the system will indicate that it is READY TO ARM. The “extra” POPIT message will only be
displayed when [COMMAND 44] is entered at the D1252A (see Figure 18). Non-normal conditions in all POPITs assigned
to the master zone with the extra POPIT may not be correctly reported as opens or shorts to the D8112G. If all POPITs
assigned to this master are normal, however, a normal condition will be correctly reported.
EXTRA POPIT
(not displayed)
2.5 Z1POINTS 6
2.12 Z8POINTS 00
PROGRAMMED
2.6 Z2POINTS 6
2.7 Z3POINTS 6
2.8 Z4POINTS 6
2.9 Z5POINTS 6
2.10 Z6POINTS 00
2.11 Z7POINTS 00
MASTER ZONE 1: 6
MASTER ZONE 2: 6
MASTER ZONE 3: 6
MASTER ZONE 4: 6
MASTER ZONE 5: 7
INSTALLED
Figure 18: Extra POPIT Installed
Installations described in Figure 17 and Figure 18 are similar, Figure 17 will display the “extra” POPIT condition because all
POPIT switch settings assigned to master zone 5 are unique. In Figure 19, the “extra” POPIT condition is not displayed due to
the duplication of switch settings.
If a POPIT is assigned to the wrong master zone, and it has the same switch settings as a POPIT in that master zone, the
“missing” POPIT condition will be indicated but the “extra” POPIT will NOT be displayed (see Figure 19). Although the
installations described in Figure 17 and Figure 19 are similar, Figure 19 will display the “extra” POPIT condition because all
POPIT switch settings assigned to master zone 5 are unique. In Figure 19, the “extra” POPIT condition is not displayed due to
the duplication of switch settings.
2.5 Z1POINTS 6
2.12 Z8POINTS 00
PROGRAMMED
2.6 Z2POINTS 6
2.7 Z3POINTS 6
2.8 Z4POINTS 6
2.9 Z5POINTS 6
2.10 Z6POINTS 00
2.11 Z7POINTS 00
MASTER ZONE 1: 6
MASTER ZONE 2: 6
MASTER ZONE 3: 6
MASTER ZONE 4: 5
MASTER ZONE 5: 7
MISSING
POPIT
TWO POPITS installed
have same switch setting
(EXTRA POPIT not
displayed)
INSTALLED
Figure 19: POPIT Switch Setting Error