IPv4 Filter
To restrict the range of IP addresses within which you can
actively connect to the device, fill-in an IP address and mask.
Two ranges can be defined.
4 Click Set and confirm to restrict access.
If either of these ranges are set, no IP V6 addresses are allowed
to actively connect to the device.
The device itself may initiate a connection (for example, to send
an alarm) outside the defined ranges if it is configured to do so.
13.8
Camera Browser
Interface
Network | en 103
Bosch Security Systems 2015.04 | v1.592 | AM18-Q0678
To Next Page
Loading...