View Control ROI
When the Stream 2 encoder stream is set for Region of Interest
(ROI), a specific type of View Control panel is activated for
electronic pan, tilt and zoom control (E-PTZ).
Refer to Encoder Streams for more information on setting up
Stream 2. (If dual ROI is available, open the camera in a second
browser window to set up the ROI on Stream 2.)
Zoom
To zoom in on a region of the stream 2 image:
1. Click and hold
to zoom in; click and hold to
zoom out.
2. Click to see the full image.
Select an area
To select a particular region of the image:
1. Click and hold the arrows to move up and down, and from
side to side through the image.
2. Click and hold the center area to move in all directions.
Set positions
To store the current view:
1. Select a region of interest.
2. Click Set.
3. Click a number.
To display a pre-set region of interest, click one of the buttons
numbered one to six.
3.1.2
Camera Browser
Interface
Operation via the browser | en 15
Bosch Security Systems 2015.04 | v1.592 | AM18-Q0678
To Next Page
Loading...