Interfaces
Alarm input
Configure the alarm triggers for the unit.
Select N.C. (Normally Closed) if the alarm is to be triggered by
opening the contact.
Select N.O. (Normally Open) if the alarm is to be triggered by
closing the contact.
Name
Enter a name for the alarm input. This is then displayed below
the icon for the alarm input on the LIVE page (if configured).
Action
Select a type of action to be performed when an alarm input
occurs:
– None
– Monochrome
This switches the camera to the monochrome mode.
– Switch mode
When this is selected, you can select the Scene Mode to be
used for the active and inactive period of the alarm.
12
12.1
12.1.1
12.1.2
88 en | Interfaces
Camera Browser
Interface
2015.04 | v1.592 | AM18-Q0678 Bosch Security Systems
To Next Page
Loading...