Divar 700 Series Advanced configuration | en 69
Bosch Security Systems Installation and Operation manual F.01U.246.471 | v3.4 | 2011.06
Manual setup
Figure 6.6 Configuration menu - Video & Audio - IP camera manual setup
1. Click Manual setup ... to configure or change an IP camera connection.
– IP address - enter the IP address of the IP camera.
– Input - Choose Camera for a camera or a single-channel encoder. Choose Video line
1-4 for a multi-channel encoder.
– Stream - enter the stream number.
– Encoder profile - Displays the encoder profile of the IP device.
– Username/Password - enter the username and password if applicable.
2. Press OK to confirm settings.
It can take a few seconds to establish a successful connection, after which a video preview
appears.
To Next Page
Loading...
