80 en | Advanced configuration Divar 700 Series
F.01U.246.471 | v3.4 | 2011.06 Installation and Operation manual Bosch Security Systems
6.6 Motion
6.6.1 Motion detection on analog cameras
The motion detection feature is configured by selecting the tabs for each individual analog
video input.
Figure 6.12 Configuration menu - Motion on analog cameras
1. Select the Draw cells mode next to the preview window:
– To add cells, draw rectangles in the motion detection area.
– To remove cells, erase rectangles from the motion detection area.
– Select Draw all cells to activate motion detection for the entire preview area.
– Select Erase all cells to clear motion detection for the entire preview area.
– Check the Show grid box to outline grid zones.
2. Adjust the Trigger level slider to set the level of motion that will be detected. Sliding to
the right raises sensitivity, sliding to the left lowers sensitivity. The highest value detects
even the slightest motion.
3. The Motion indicator gives a visual indication of the activity detected.
4. Select Clear indicator to reset the peak level.
Note:
Tips for troublefree motion detection:
– The size of a motion area influences the sensitivity in this area. A small motion area
should be used to detect small objects (high sensitivity); a large area should be used to
detect large objects (low sensitivity).
To Next Page
Loading...
