Divar 700 Series Advanced configuration | en 85
Bosch Security Systems Installation and Operation manual F.01U.246.471 | v3.4 | 2011.06
6.8 Event
Use the Event menu to specify the desired behavior for an active contact input, detected
motion, or video loss. The general behavior of events is also set here. Each of the six profiles
has a General, Contact, Motion, Text and Video loss tab.
Figure 6.16 Configuration menu - Event - General
6.8.1 General
Auto acknowledge alarms
– Enable when alarms should be acknowledged automatically. By default, an alarm must be
manually acknowledged.
Alarm dwell time
– Set between 1 and 59 seconds to select the period during which the output relay and the
beeper remain active after activation of the alarm.
Sound beeper on alarm
– Enable an audible warning upon an alarm.
Sound beeper on video loss
– Enable an audible warning upon video loss.
Actions when entering this profile
Click Edit... to specify pre-positions for PTZ cameras when this profile is started.
– Enter a pre-position number from 1-1023 for each of the PTZ cameras that should be
moved (PTZ must be enabled for corresponding camera input).
Any actions that have been configured are listed.
To Next Page
Loading...
