Bosch Divar 700 Series - Setup - Connection 1

Divar 700 Series Advanced configuration | en 89
Bosch Security Systems Installation and Operation manual F.01U.246.471 | v3.4 | 2011.06
6.9.2 Setup - Connection 1
Figure 6.18 Configuration menu - Network - Setup - Connection 1
Set up the network parameters for the primary Ethernet port.
–Enable DHCP to have IP address, subnet mask, and default gateway assigned
automatically by the network DHCP server. The actual values are displayed.
– If DHCP is disabled, fill in the IP address, the Subnet mask, and the Default gateway
address for the recorder.
–If Auto DNS address is not enabled, then fill in the DNS Server address.
– The MAC address is read only; it shows the MAC address of the Ethernet adapter.
– Connection shows the status of the physical network connection.