Divar 700 Series Advanced configuration | en 75
Bosch Security Systems Installation and Operation manual F.01U.246.471 | v3.4 | 2011.06
6.4 Recording
Use the Recording menu to configure the recording set-up for each of the six profiles.
Note:
The audio/video settings in a profile also apply to the stream used for remote live viewing.
Figure 6.10 Configuration menu - Recording - Normal
The recording behavior for each of the six profiles is specified in three submenus and then for
each individual channel.
1. Select a profile.
2. Choose an individual input channel to configure the settings for recording its video and
audio.
3. Select a submenu for Normal, Contact, or Motion recording.
– Normal recording - the default recording mode
– Contact recording - activated upon an contact input event
– Motion recording - activated upon a motion event
6.4.1 Normal
Set values for each of the following fields:
– Normal recording mode:
– Continuous - set to record continuously
– Event only - set to record events only
– No Recording - set to disable recording
– Pre-Event Time:
– set between 1 and 120 seconds (only applicable when recording Event only). The
recoding for the event starts this amount of time before the event occcurs.
To Next Page
Loading...
