Divar 700 Series Advanced configuration | en 97
Bosch Security Systems Installation and Operation manual F.01U.246.471 | v3.4 | 2011.06
Figure 6.26 Configuration menu - Storage - Disks - All
All disks
All available disks are shown in the list.
– Select Internal disks to see a list of installed internal disks and their capacity in
gigabytes.
– iSCSI disk locations are also shown. Locations can be added or removed from the list by
clicking Add location or Remove location.
–When Add location is selected, a pop-up window appears; fill in the IP address and
port of the iSCSI array to be added.
– Select an individual hard disk from the list and click Properties to view the status of the
selected disk.
6.10.3 Service
– Delete recording until... - opens a submenu to delete video older than a specified date.
– Delete all recordings - will erase all video on all hard disks in the active disk set
(protected drives will also be erased).
– Pause recording... - pauses all recordings for a specified period of time.
6.10.4 Raid 4 protection
Divar 700 series recorders have a licensed RAID 4 protection feature. When this feature is
active, the recordings are safe, even if one of the hard drives should fail. The RAID feature
requires 4 drives to operate. The net capacity of hard disk space available in RAID mode is 3
times the size of the smallest hard disk in the recorder. So if 4*1 TB is installed, the net
capacity for recordings is 3 TB. If you have 1*500 GB and 3*1 TB hard disks, the net capacity
is 3*500 GB or 1.5 TB.
To Next Page
Loading...
