DX4010V2 | Installation Instructions | Contents
Bosch Security Systems, Inc. | 9/08 | F01U083036-01 3
Contents
1.0 General Information ....................................4
2.0 Specifications ..............................................4
3.0 Installation Standards .................................4
4.0 Wiring........................................................... 5
5.0 DX4010V2 Jumper Pin Settings ................ 6
5.1 Enable LED Jumper Pins (P2) ..................... 6
5.2 DB9 Ground Enable Pins (P1) ..................... 6
5.3 Address DIP Switches.................................. 7
6.0 Remote Programming Direct Connection 7
7.0 DB9 DTE RS-232 Connector (P6) ............ 10
8.0 RJ-16 Data Bus Connector (P3) .............. 11
9.0 USB Data Bus Connector ........................ 11
9.1 Installing USB Drivers ................................ 11
Figures
Figure 1: DX4010V2 Component Layout .............. 4
Figure 2: Control Panel Connections .................... 5
Figure 3: External Power Supply Connections...... 5
Figure 4: Serial Device Connections..................... 5
Figure 5: Parallel Device Connections.................. 6
Figure 6: P2 Jumper Settings ............................... 6
Figure 7: DIP Switch Location and Orientation ..... 7
Figure 8: DB9 Connector Layout ........................ 10
Figure 9: P3 Connector....................................... 11
Figure 10: Select File............................................ 11
Figure 11: Security Warning ................................. 11
Figure 12: Install Shield ........................................ 11
Figure 13: Security Warning ................................. 11
Figure 14: Destination Location ............................ 12
Figure 15: Ready to Install.................................... 12
Figure 16: Setup Status ........................................ 12
Figure 17: Installation Complete ........................... 12
Figure 18: USB Driver Installer ............................. 12
Figure 19: Scanning.............................................. 12
Figure 20: Installation Complete ........................... 12
Figure 21: System Properties ............................... 13
Figure 22: Device Manager................................... 13
Figure 23: Panel Communication.......................... 13
Tables
Table 1: DX4010V2 Specifications ...................... 4
Table 2: Diagnostic LED Functions ..................... 6
Table 3: Option Bus Address DIP Switch Settings8
Table 4: SDI Bus Address DIP Switch Settings ... 9
Table 5: Alternate Wiring Configuration............. 10
To Next Page
Loading...
