EasyManua.ls Logo

Bosch ETT 008.31 - Recognition of Chopper Motor; Procedure for Setting Appropriate Version for Country of Use

Bosch ETT 008.31
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
30
Press "Select" Display Meaning/function
The analyzer then automatically switches to the "
Ab5oAb5o
Ab5oAb5o
Ab5o" fine-
tuning function.
The display "700" appears in the CO display field.
Adjustment range: 700 hPa to 1100 hPa
Perfrom fine-tuning with the "Enter o" or "Test u" buttons.
After this, do not press any buttons; wait.
After two seconds, "
EndEnd
EndEnd
End" appears, the analyzer has provisio
nally accepted the value (the pressure must have remained
constant until this moment).
As with fine-tuning of the first reference point, now acknow-
ledge your entry by simultaneously pressing the "Enter o"
and "Test u" buttons.
This finalizing routine is the same after the fine-tuning of both
reference points, even if the second reference point has
been fine-tuned in cm water gauge.
The analyzer conforms correct fine-tuning with the display
"
i.0.i.0.
i.0.i.0.
i.0." (OK) in the engine-speed display field.
Open the zero-gas inlet of the analyzer so that the air-
pressure gauge can set itself to ambient pressure. Only
then, press the "Select" button; the analyzer now quits fine-
tuning.
6.6 Recognition of chopper motor
i Set function switch S 60 to setting 1
Press "Select" Display Meaning/function
5 x An automatic sequence takes place:
The counter in the engine-speed display window counts
backwards from "15" to "0". During this time, the exhaust-
gas analyzer recognizes which chopper motor is installed.
The following identification codes may appear:
PHiLPHiL
PHiLPHiL
PHiL = Phillips/Valvo motor or interchangeable model.
bEr9bEr9
bEr9bEr9
bEr9 = Berger motor or interchangeable model.
6.7 Procedure for setting appropriate version for country of use
i Set function switch S 60 to setting 2
Press "Select" Display Meaning/function
5 x With the "Enter o" or "Test u" buttons, select the desired
setting. The following settings are available:
U 13 UU 13 U
U 13 UU 13 U
U 13 U = Standard
U 13 EU 13 E
U 13 EU 13 E
U 13 E = UK
U 13 CU 13 C
U 13 CU 13 C
U 13 C = not used
U 13 bU 13 b
U 13 bU 13 b
U 13 b = Brazil
984 700
Ab5o bo.Ei
984 980
i.0. bo.Ei
15 Ch.Ei
PHiL Ch.Ei
U13U tY.Ei

Table of Contents

Related product manuals