Bosch FCS-8000-VFD-B - Monitoring Center; Fire Alarm Control Panel

AVIOTEC IP starlight 8000 Installation | en 33
Bosch Sicherheitssysteme GmbH Operation manual 2019.01 | 10 | F.01U.318.200
5.4 Wiring of the camera
Connection to Ethernet via PoE Ethernet cable
Notice!
Use only PoE approved devices.
The camera is intended to be powered via a STP Category 5e cable in a Power-over-Ethernet
(PoE) network environment . This is the default power supply.
1. Connect the camera to a 10/100 Base-T network.
2. Use STP Category 5e cable with RJ45 connectors (the camera network socket is Auto
MDIX compliant).
P The LEDs beside the Ethernet connection indicate network connection (green lit) and IP
traffic (orange flashing).