Bosch FCS-8000-VFD-B - Camera

AVIOTEC IP starlight 8000 Adjustment of detection settings | en 45
Bosch Sicherheitssysteme GmbH Operation manual 2019.01 | 10 | F.01U.318.200
Add mask
You can define individual areas in which the detection will be deactivated. These masks can
easily be added to the picture area.
To add a mask, perform the following steps:
1. Click on the button Add mask.
A rectangle with a crossed out flame and smoke icon will appear in the middle of the
picture area.
In Properties you can deselect Mask flames or Mask smoke.
2. Change the size and shape of the rectangle to your specific needs.
3. Move the mask to the desired area in the picture.
4. Select Set to confirm the changes.
Add smoke time region
Detection disturbing elements in the application of the customer, e.g. roller shutter, can be
masked out. In this specific mask, the smoke detection will be delayed. This functionality is
not applicable in masks with deactivated smoke detection.
To add this mask, perform the following steps:
1. Click on the button Add smoke time region.
A rectangle with a clock icon will appear in the middle of the picture area.
2. In Properties select or type in the Verification time [s].
The value must be set from 5 to 120 seconds. Default value is 30 seconds.
3. Move the mask to the desired area in the picture.
4. Change shape and size to your specific needs.
5. Select Set to confirm the changes.
Automask
Notice!
All automasks stored in the volatile alarm memory of the camera are lost when the supply
voltage is interrupted or switched off. Automasks that already have been saved will remain
unaffected.
Notice!
If you change the settings of Min. size or Verification time [s], it is necessary to renew the
automasks.
1. Navigate to Configuration > Alarm > Fire detection.
2. Select Automask
The system automatically generates predefined masks from the alarm memory. The
automasks are illustrated as rectangles with red dashed border.
3. Adjust the automask to your specific needs.
If it is necessary, you can add individual masks (Add mask).
4. Select Set to confirm the changes.
P Automasks were added to the system.