Bosch FLEXIDOME corner 7100i IR - Customer Service

20 en | Troubleshooting FLEXIDOME corner 7100i IR
2023-10 | 01 |
Installation Manual
Bosch Security Systems
– The device is not properly connected to the network. Check the cable connections in
this case.
– The device is not correctly integrated into the network. Check the IP address, subnet
mask, and gateway address.
i
Notice!
The ping command only works when ping response is not disabled in the device.
6.3 Customer service
If a fault cannot be resolved, please contact your supplier or system integrator, or go
directly to BoschSecuritySystems Customer Service.
The version numbers of the internal firmware can be viewed on a service page. Please note
this information before contacting Customer Service.
1. In the address bar of your browser, after the unit IP address, enter: /version
for example: 192.168.0.80/version
2. Write down the information or print out the page.