Bosch FLEXIDOME IP 3000i IR - Enhance

FLEXIDOME IP 3000i IR | FLEXIDOME IP micro
3000i | DINION IP 3000i IR | FLEXIDOME IP turret
3000i IR
Configuration | en 27
Bosch Security Systems B.V. User manual 2020-01 | V02 | DOC
4.3.4 Enhance
High dynamic range
Choose between these options:
Off: to disable High Dynamic Range (HDR)
Auto: for automatic HDR. Depending on the scene, the camera can capture multiple exposures
to increase the Dynamic Range
Extreme: similar to Auto, but with even higher Dynamic Range. Use this only in quiet scenes
and with low light levels. Artifacts can occur depending on the light level and movement in the
scene.
Notice!
Do not use HDR in scenes with fluorescent lighting.
HDR can only be active if Auto exposure is selected, and there is a match between the base
frame rate (selected in the installer menu) and the ALC fluorescent mode frequency. If there
is a conflict, a pop-up window will suggest a solution and adjust the appropriate settings.
Backlight compensation
Select Off to switch off backlight compensation.
Select On to capture details in high-contrast and extremely bright-dark conditions.
Contrast enhancement
Select On to increase the contrast in low contrast conditions.
Intelligent Defog
Select this to activate the automatic intelligent defog feature. This feature continuously
adjusts image parameters to provide the best picture possible under foggy or misty
conditions.
Intelligent Dynamic Noise Reduction
Select On to activate intelligent Dynamic Noise Reduction (DNR) which reduces noise based
on motion and light levels.
Sharpness level
Adjusts the Sharpness level between -15 and +15. A low (negative) value makes the picture
less sharp. Increasing sharpness brings out more detail. Extra sharpness can enhance the
details of license plates, facial features and the edges of certain surfaces but can increase
bandwidth requirements.
Temporal noise filtering
Adjusts the Temporal noise filtering level between -15 and +15. The higher the value, the
more noise filtering.
Spatial noise filtering
Adjusts the Spatial noise filtering level between -15 and +15. The higher the value, the more
noise filtering.
Intelligent streaming
The sharpness level, Temporal noise filtering and Spatial noise filtering can be automatically
adjusted here, through the encoder, for optimum intelligent streaming results.
Dynamic sharpness & noise filtering
Enable or disable the automatic adjustment of the encoder.
Priority encoder stream
Select stream 1, 2 or Auto as the priority stream for the encoder. Auto automatically selects
the optimal stream.