Bosch FLEXIDOME IP 3000i IR - Advanced

48 en | Configuration
FLEXIDOME IP 3000i IR | FLEXIDOME IP micro
3000i | DINION IP 3000i IR | FLEXIDOME IP turret
3000i IR
2020-01 | V02 | DOC User manual Bosch Security Systems B.V.
User name
Enter the user name you registered.
Password
Enter the password you registered.
Force registration now
Force the registration by transferring the IP address to the DynDNS server. Entries that
change frequently are not provided in the Domain Name System. It is a good idea to force the
registration when setting up the device for the first time. Only use this function when
necessary and no more than once a day, to avoid the possibility of being blocked by the
service provider. To transfer the IP address of the device, click the Register button.
Status
The status of the DynDNS function is displayed here for information purposes; these settings
cannot be changed.
Click Set to apply the changes.
4.7.4 Advanced
Cloud-based services
Operation
The operation mode determines how the camera communicates with Cloud-based Security
and Services.
– Select Auto to allow the camera to poll the server a few times; if no contact is made, it
stops polling.
– Select On to constantly poll the server.
– Select Off to block polling.
Cloud state
This field identifies any cloud-based services with which the camera communicates.
– If you have registered the device on a cloud-based service such as Bosch Remote Portal,
then this field identifies this fact (“Registered on Bosch Remote Portal”).
Note: The button (Connect to Bosch Remote Portal) to connect to the device with that
service is active.
– If you have not registered the device, then the message, “Not running. (Automatic IP
assignment not active)“ appears.
Note: The button (Connect to Bosch Remote Portal) to connect to the device with that
service is not active.
Stratocast
Enter the Stratocast Registration code to connect with the Genetec’s Stratocast cloud.
Click Register to activate the account.
RTSP port
If necessary, select a different port for the exchange of the RTSP data from the list. The
standard RTSP port is 554. Select Off to deactivate the RTSP function.
Authentication (802.1x)
To configure Radius server authentication, connect the unit directly to a computer using a
network cable. If a Radius server controls access rights over the network, select On to activate
authentication to communicate with the unit.
1. Enter the user name that the Radius server uses for the unit in the Identity field.
2. Enter the Password that the Radius server expects from the unit.