6 720 643 262 (2010/05)
16 | Operation with open flap US/CA
5.3 Constant room temperature
If, however, you would like to specify a constant
room temperature for a longer time, then you can
set constant operation with the operating mode
selector.
The following constant room temperature
settings are possible:
• : Comfort in permanent operation
The controls constantly regulate the set (high)
room temperature for the Comfort operating
mode. (Factory settings): 70 °F (21 °C).
• : Economy in permanent operation
The controls constantly regulate the set (high)
room temperature for the Economy operating
mode. (Factory settings): 60 °F (15 °C).
• : Frost in permanent operation
The controls constantly regulates the set
(low) room temperature for the Frost
operating mode. (Factory settings): 42 °F
(5 °C). If the boiler is switched on, there is
frost protection for the system. Please
observe the other notes in the boiler
operating instructions.
B Open flap.
B If desired, press dial to change the heating
circuit.
B Turn operating mode selector to the desired
position.
If possible, leave the operating
mode selector in the position.
Only this way can you benefit from
the full comfort of the heating
program.
NOTICE: Make sure that the lower
room temperature is tolerable for
plants and house pets.
You can change the set
temperature with the dial
(Æ section 4.2). If the operating
mode selector is turned, the
changed temperature is discarded.
To Next Page
Loading...
