Bosch FWA 44 Series - Camera Recovery Tool; Backup; Recovery

1 690 326 006 2008-8-25| Robert Bosch GmbH
Operating System-Software | FWA 43xx / 44xx | 47 en
Camera Recovery Tool14.10
Function14.10.1
Camera data (version info and coefficients) can be
R
saved and recovered with the help of the program.
The program is available only on the service CD.
R
Before updating the firmware, the data should be
saved by means of the Camera Recovery Tool.
The Camera Recovery Tool functions only with the
i
cable connection.
Backup14.10.2
Start BackupFig. 12:
By selecting the Start Backup, the camera data of all R
the located sensors are read out and saved in a file
per camera at each time.
The files are in the directory:C:\<program files>\
R
FWA-CCD\Wheelaligner\CCD\Camera
A new sub-directory is created here with the date
R
and time in case of every backup. The serial
numbers of the cameras are used as file name.
Serial number as file nameFig. 13:
Recovery14.10.3
Recovery of camera data Fig. 14:
Recovery of camera data in 3 steps:
Camera data file: Selection of the camera file with 1.
Open File.
Camera selection: Selection of the camera to be 2.
described.
Serial number of the camera should match the file
i
number (as a label on the camera).
Start of recovery with Write to camera.3.
Further tips
The following order shall be adhered to in case
i
the lost camera data should be recovered and
a firmware update should be carried out: