16 | English
1 609 929 S54 | (8.12.08) Bosch Power Tools
Technical Data
Assembly
f Avoid unintentional starting of the ma-
chine. During assembly and for all work on
the machine, the power plug must not be
connected to the mains supply.
Delivery Scope
Before starting the operation of the machine for
the first time, check if all parts listed below have
been supplied:
– Sliding mitre saw with premounted saw
blade
– Dust bag 31
– Quick-action clamp 39
– Allen key/Phillips screwdriver 26
Note: Check the power tool for possible dam-
age.
Before further use of the machine, check that all
protective devices are fully functional. Any light-
ly damaged parts must be carefully checked to
ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Stationary or Flexible Mounting
f To ensure safe handling, the machine must
be mounted on a level and stable surface
(e. g., workbench) prior to using.
Mounting to a Working Surface
– Fasten the power tool with suitable screw
fasteners to the working surface. The holes
15 serve for this purpose. (see figure A1)
or
– Clamp the power tool with commercially
available screw clamps by the feet to the
working surface. (see figure A2)
Sliding Mitre Saw GCM 800 S
Professional
Article number
3 601 L16 1..
Rated power input
W 1400
Rated voltage
V 230
Frequency
Hz 50/60
No-load speed
min
-1
5000
Weight according to
EPTA-Procedure
01/2003
kg 15
Protection class
/II
Maximum workpiece dimensions, see page 20.
Starting cycles generate brief voltage drops. Interfer-
ence with other equipment/machines may occur in
case of unfavourable mains system conditions. Mal-
functions are not to be expected for system impedanc-
es below 0.24 ohm.
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Dimension of suitable saw blades
Saw blade diameter
mm 210–216
Blade thickness
mm 1.5–2.8
Mounting hole diameter
mm 30
OBJ_BUCH-884-002.book Page 16 Monday, December 8, 2008 2:26 PM
To Next Page
Loading...
