18 | English
1 609 929 S54 | (8.12.08) Bosch Power Tools
Removing the Saw Blade
– Push the locking lever 32 and swing the re-
tracting blade guard 6 to the rear to the stop.
– Loosen the screw 33 with the Phillips screw-
driver 26 provided until the fastening ele-
ment of the retracting blade guard can also
be swung to the rear to the stop.
– Turn the Allen screw 35 with the Allen key 26
provided while at the same time pressing the
spindle lock 34 until it engages.
– Hold the spindle lock 34 pressed and un-
screw the Allen screw 35 in clockwise direc-
tion (left-hand thread!).
– Remove the clamping flange 36.
– Remove the saw blade 37.
Mounting the Saw Blade
If required, clean all parts to be mounted prior
to assembly.
– Place the new saw blade onto the interior
clamping flange 38.
f When mounting the saw blade, pay atten-
tion that the cutting direction of the teeth
(arrow direction on the saw blade) corre-
sponds with the direction of the arrow on
the blade guard!
– Place on the clamping flange 36 and the Allen
screw 35. Press the spindle lock 34 until it
engages and tighten the Allen screw turning
in anticlockwise direction.
– Fasten the retracting blade guard 6 again
(tighten screw 33).
– Push the locking lever 32 and guide the re-
tracting blade guard down again.
Operation
f Before any work on the machine itself, pull
the mains plug.
Transport Safety
(see figure E)
The transport safety-lock 27 enables easier han-
dling of the machine when transporting to vari-
ous working locations.
Releasing the Machine (Working Position)
– Push the tool arm by the handle 5 down a lit-
tle in order to relieve the transport safety-
lock 27.
– Pull the transport safety-lock 27 completely
outward.
– Guide the tool arm slowly upward.
Securing the Machine (Transport Position)
– Push the locking lever 32 and at the same
time move the tool arm by the handle 5
downward.
– Guide the tool arm downward until the trans-
port safety-lock 27 can be pushed complete-
ly inward.
Preparing for Operation
Enlarging the Fence
(see figure F)
For better positioning of especially large profile
strips, a higher fence is necessary. For this pur-
pose, the fence 18 is equipped with four holes
(Ø 6 mm) onto which suitable wood pieces can
be mounted.
f This auxiliary fence may be used only for 0°
mitre cuts. The functions of the machine
(especially of the retracting blade guard)
must not be impaired.
– Screw the wooden pieces (max. height
62 mm) onto the fence rails. The screw
heads must be flush with the wood surface
or countersunk.
OBJ_BUCH-884-002.book Page 18 Monday, December 8, 2008 2:26 PM
To Next Page
Loading...
