English | 23
Bosch Power Tools 1 609 929 S54 | (8.12.08)
Checking and Adjusting the Basic
Adjustment
To ensure precise cuts, the basic adjustment of
the machine must be checked and adjusted as
necessary after intensive use.
A certain level of experience and appropriate
specialty tools are required for this.
A Bosch after-sales service station will handle
this maintenance task quickly and reliably.
Aligning the Angle Indicator (Horizontally)
(see figure O)
– Bring the power tool into the working posi-
tion.
– Turn the saw table 7 to the 0° detent 14. The
lever 12 must be felt to engage in the detent.
Checking:
The angle indicator 13 must be in alignment
with the 0° mark of the scale 8.
Adjusting:
– Loosen the screw 44 with the Phillips screw-
driver provided and align the angle indicator
along the 0° mark.
– Retighten the screw again.
Aligning the Angle Indicator (Vertically)
(see figure P)
– Bring the power tool into the working posi-
tion.
– Turn the saw table 7 to the 0° detent 14. The
lever 12 must be felt to engage in the detent.
Checking:
The angle indicator 20 must be in alignment
with the 0° mark of the scale 19.
Adjusting:
– Loosen the screw 45 with the Phillips screw-
driver provided and align the angle indicator
along the 0° mark.
– Afterwards, check to ensure that the adjust-
ment made is correct for the 45° mark.
– Retighten the screw again.
Aligning the Fence
– Bring the machine into the transport posi-
tion.
– Turn the saw table 7 to the 0° detent 14. The
lever 12 must be felt to engage in the detent.
Checking: (see figure Q1)
– Set an angle gauge to 90° and place it on the
saw table 7 between the fence 18 and the
saw blade 37.
The leg of the angle gauge must be flush with
the fence over the complete length.
Adjusting: (see figure Q2)
– Loosen all Allen screws 24 with the Allen key
provided.
– Turn the fence 18 until the angle gauge is
flush over the complete length.
– Retighten the screws again.
Setting the Standard Bevel Angle 0°
(Vertical)
– Bring the machine into the transport posi-
tion.
– Turn the saw table 7 to the 0° detent 14
. The
lever 12 must be felt to engage in the detent.
Checking: (see figure R1)
– Set an angle gauge to 90° and place it on the
saw table 7.
The leg of the angle gauge must be flush with
the saw blade 37 over the complete length.
Adjusting: (see figure R2)
–Turn the Allen screw 46 in or out using a suit-
able Allen key (size 3 mm) until the leg of the
angle gauge is flush with the saw blade over
its complete length.
In case the angle indicator 20 is not in a line with
the 0° mark of the scale 19 after the adjust-
ment, the angle indicator must be aligned ac-
cordingly (see “Aligning the Angle Indicator
(Vertically)”, page 23).
OBJ_BUCH-884-002.book Page 23 Monday, December 8, 2008 2:26 PM
To Next Page
Loading...
