24 | English
1 609 929 S54 | (8.12.08) Bosch Power Tools
Setting the Standard Bevel Angle 45°
(Vertical)
– Bring the power tool into the working posi-
tion.
– Turn the saw table 7 to the 0° detent 14. The
lever 12 must be felt to engage in the detent.
– Release the clamping lever 22 and tilt the
tool arm leftward to the stop (45°) by the
handle 5.
Checking: (see figure S1)
– Set an angle gauge to 45° and place it on the
saw table 7.
The leg of the angle gauge must be flush with
the saw blade 37 over the complete length.
Adjusting: (see figure S2)
– Turn the Allen screw 47 in or out using a suit-
able Allen key (size 3 mm) until the leg of the
angle gauge is flush with the saw blade over
its complete length.
In case the angle indicator 20 is not in a line with
the 45° mark of the scale 19, firstly check the 0°
setting for the bevel angle and the angle indica-
tor again. Then repeat the adjustment of the 45°
bevel angle.
Transport
(see figure T)
– Loosen the locking screw 25 if tightened.
Pull the tool arm completely to the front and
tighten the locking screw again.
– Screw the depth stop 23 all the way up or
turn the depth stop lever 42 in clockwise di-
rection back to the stop.
– Bring the machine into the transport posi-
tion.
– Carry the machine by the transport handle 2
or hold it by the recessed grips 48 on the
sides of the saw table.
f The power tool should always be carried by
two persons in order to avoid back injuries.
f When transporting the power tool, use only
the transport devices and never use the
protective devices.
Maintenance and Service
Maintenance and Cleaning
f Before any work on the machine itself, pull
the mains plug.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
Cleaning
For safe and proper working, always keep the
power tool and its ventilation slots clean.
The retracting blade guard must always be able
to move freely and retract automatically. There-
fore, always keep the area around the retracting
blade guard clean.
Remove dust and chips after each working pro-
cedure by blowing out with compressed air or
with a brush.
Clean the roller 9 regularly.
Replacing the Carbon Brushes
(see figure U)
Check the length of the carbon brushes approx.
every 2–3 months and replace the carbon
brushes if required.
Never replace only a single carbon brush!
Criteria for replacement of the carbon brushes:
A dotted or broken line is visible on one of the
large side surfaces of each carbon brush. When
either of both carbon brushes is used up to this
line, then both carbon brushes should be re-
placed immediately in order to protect the ar-
mature against possible damage.
Note: Use only carbon brushes supplied by
Bosch and intended specifically for your prod-
uct.
– Unscrew the caps 49 using a suitable screw-
driver.
– Replace the spring-loaded carbon brushes
50 and screw the caps back on again.
OBJ_BUCH-884-002.book Page 24 Monday, December 8, 2008 2:26 PM
To Next Page
Loading...
