18
Using the Head Assembly Lock Pin
HEAD ASSEMBLY LOCK PIN
The head assembly lock pin (Fig. 8) is used to hold
the saw’s head assembly in the DOWN position.
This position prevents the head from bouncing up
and down during transportation. This also makes
t
he saw more compact for lifting and storage. This
position is also required for some calibrating
procedures.
TO ENGAGE THE HEAD ASSEMBLY LOCK PIN:
1. Check that the depth stop plate is disengaged,
pressed in against saw head, (Fig. 9).
2. Grasp the saw’s main handle and press down on
the head assembly.
3. While pressing the saw head down, push in on
the head assembly lock pin, (Fig. 8). Release the
head assembly. The head will be locked in the
DOWN position.
TO DISENGAGE THE HEAD ASSEMBLY
LOCK PIN:
1. Grasp the main handle and press down on the
head assembly.
2. While pressing the head down, pull out the head
assembly lock pin. Release the lock pin, but
maintain your grip on the main handle. Slowly
allow the spring-loaded saw head to come up to
the top of its travel and then release the handle.
Fig. 8
Fig. 9
Head
Assembly
Lock Pin
Depth
Stop
Plate
Assembly
To Next Page
Loading...
