31
Miter Detent System
USING MITER DETENT SYSTEM
1. Loosen the miter lock knob about 1/2 turn (see
Fig. 34).
2. Grip the lock knob, and then reach down with
your index finger to pull up on the miter detent
lever – pull lever until it is out from the miter
detent.
3. While gripping the miter lock knob and miter
detent lever, rotate the saw’s table. Stop table
rotation at the desired angle as indicated by the
miter scale pointer.
4. Release the miter detent lever into a detent or at
an angle between detents.
5. Tighten the miter lock knob before cutting.
NOTE: It is recommended to tighten the miter lock
knob before all cuts. It is required to tighten the
knob before cutting at any angle between detents.
ADJUSTING FRONT STABILIZING FOOT
The front stabilizing foot is located at the front of
the saw’s table near the miter detent lever
(Fig. 34). This foot provides additional support
and stability when making slide cuts. To adjust the
foot to the work surface follow these steps:
1. Place the saw on the intended work surface.
2. Set desired miter angle.
3. Unscrew (turn counter clockwise) the front
stabilizing foot until it contacts the work surface.
4. Screw in (turn clockwise) the front stabilizing
foot if it prevents the tool from making full
contact (all four base feet touching) with the
work surface.
Note: if the saw is firmly attached to a bench using
all mounting holes the front stabilizing foot can be
adjusted clockwise into the saw and does not need
to be adjusted to the work surface (refer to page
24, How to mount the saw to a bench).
Miter Detent Lever
Miter Lock Knob
Detents
Fig. 34
Front
Stabilizing Foot
Saw Operations
To avoid possible injury, disconnect battery pack before performing any assembly,
a
djustments or repairs.
To Next Page
Loading...
