14
Getting To Know Your Miter Saw
22. Sliding Base Extensions – Provide extra work sup-
port. Useful when cutting long workpieces.
23. Rubber Deflector – Attaches to bottom of chute.
Deflects dust into the chute.
24. Dust Chute – Directs sawdust up and through the
elbow and to the bag.
25. Elbow – Connects the dust chute to the dust bag. Can
be rotated to direct dust.
26. Dust Bag – Has a zipper at the bottom. Bag can be
uncoupled from elbow for emptying.
27. Mechanism Lock Lever – Holds saw in full back posi-
tion for chop cuts or fully extended for transporting.
28. Link Knob – Attaches guard link to the pivot post.
29. Lower Guard Link – Allows for smooth movement of
the lower guard.
30. Clamp – Use to hold the workpiece to the table and
base – insert into clamp post location (item 39).
31. Connectivity Module Compartment – Bosch Con-
nectivity Module is used to connect the tool to Bosch
Toolbox app on a mobile device.
32. Depth Stop Screw – Turn the knob end to adjust the
blade depth for cutting grooves.
33. Depth Stop Plate – Plate can be swung out to limit the
depth of the blade travel.
34. Pivot Post – Provides support for the saw head, dust
collection system and other functional parts.
35. Axial Glide Mechanism – Allows saw to smooth-
ly slide in and out. Can be locked in full rear or fully
extended positions.
36. Bevel Scale and Pointers – Scale is large and angled
- allows user to easily read bevel angles. Pointer indi-
cates what the current angle is.
37. Bevel Post – Provides rotating support for all miter
saw parts above the table.
38. Bevel Detent Pin (Crown Molding Setting) – When
engaged, it locks the head assembly to the bevel angle
of 33.9° to the left or right.
39. Clamp Post Locations – Two vertical post holes in the
base – provided to insert the clamp (item 30).
40. Miter Detent Plate Screws – Four screws accessible
through holes in the miter scale. These screws are
loosened when adjusting position of the detent plate.
41. Bevel Range Selector Knob – Allows selection of
3 bevel ranges: “0-45° Left”, “0-45° Right” or “Max.
Bevel Angle to 47°.”
42. Arbor Lock – Press arbor lock button to keep blade
from rotating when loosening or tightening arbor bolt
during blade removal or installation.
43. Head Assembly Lock Pin – Used to lock the head
assembly in the lower position for transporting.
44. Glide Movement Controller – Adjusts to regulate
movement of the glide mechanism.
45. Mounting Holes for Optional Crown Stop or Length
Stop.
46. Battery Bay – used to insert Bosch battery or
AMPShare Battery packs.
47. Battery Pack (sold separately)
48. Battery Pack Release button – used to remove bat-
tery pack from the battery bay.
49. Cast-in Carry Handles – Used for lifting and trans-
porting of saw.
50. User Interface – used to select the preset speed
levels and to indicate the status of the power tool and
battery.
51. Set Screws for Laser Line Guide – used to adjust the
laser line guides.
To Next Page
Loading...
