-11-
Bluetooth®
Do not use the laser measure with Bluetooth® in
the vicinity of gas stations, chemical plants, areas
where there is danger of explosion and areas sub-
ject to blasting. Do not use the laser measure with
Bluetooth® in airplanes. Do not use the laser measure
with Bluetooth® in the vicinity of medical devices.
Avoid operation in the direct vicinity of the human
body over longer periods of time. When using the la-
ser measure with Bluetooth®, interference with other
devices and systems, airplanes and medical devices
(e.g., cardiac pacemakers, hearing aids) may occur.
The Bluetooth® word mark and logos are registered
trademarks owned by Bluetooth SIG, Inc. and any use
of such marks by Robert Bosch Tool Corporation is
under license.
FCC Caution
The manufacturer is not responsible for radio inter-
ference caused by unauthorized modifications to this
equipment. Such modifications could void the user’s
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference,
and
2) This device must accept any interference received,
including interference that may cause undesired
operation.
NOTE! This equipment has been tested and found to
comply with the limits for a Class B digital devices,
pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates uses and can radiate radio fre-
quency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful
interference to radio communications. However, there
To Next Page
Loading...
Need help?
General
