2
L
⁄
4'02"
W
16'11"
Aim and press the measure button 2
[ ] again to take the measurement
for length which will appear on the
top line of the measured-value lines
d.
Aim and press the measure button 2
[
] again to take the measurement
for width which will appear on the
middle line of the measured-value
lines d and the area will automatically be calculated
and display on the result line e.
Volume Measurement
For volume measurements, press the function button
7 [Func] and use the plus button 3 [ ] or minus but-
ton 8 [ ] to cycle through the measurement functions
until the highlighted square appears over the indicator
for volume measurement and the word “Volume”
appears in the status bar. Select volume measurement
by pressing the measure button 2 [ ]. Activate the
laser by pressing the measure button 2 [ ]. The laser
will be switched on.
L
⁄
4'02"
0.0°
W
8'05"
H
⁄
12'08"
3
Aim and press the measure button 2
[ ] again to take the measurement for
length which will appear on the top
line of the measured-value lines d.
Aim and press the measure button 2
[
] again to take the measurement for
width which will appear on the middle
line of the measured-value lines d.
Aim and press the measure button 2 [
] again to take
the measurement for height which will appear on the
bottom line of the measured-value lines d and the vol-
ume will automatically be calculated and display on
the result line e.
To Next Page
Loading...
Need help?
General
