]. Activate the
laser by pressing the measure button 2 [ ]. The laser
will be switched on. Aim the laser at the object you
want to measure the distance to. Press the measure
button 2 [ ] again to take the measurement. The mea-
surement will be shown in the result line e.
0.0°
⁄
4'02"
8'05"
⁄
12'07"
Press the measure button 2 [ ] and
the previous measurement will move
to the bottom line of the measured-
value lines d.
Press the measure button 2 [
] for a
new measurement which will display
on the result line e.
Press the measure button 2 [
] and
the measurement from the bottom line
of the measured-value lines d will move to the middle
line of the measured-value lines d and the measure-
ment from the result line e will move to the bottom line
of the measured-value lines d.
Press the measure button 2 [
] for a new measure-
ment which will display on the result line e.
As you continue to take measurements, this cycle will
continue. The unit can display up to 3 previous mea-
surements.
The last three measurements will display on the mea-
sured-value lines d and the current measurement will
display on the result line e.
Area Measurement
For area measurements, press the function button 7
[Func] and use the plus button 3 [ ] or minus but-
ton 8 [ ] to cycle through the measurement functions
until the highlighted square appears over the indica-
To Next Page
Loading...
Need help?
General
