-31-
Inclination measurement is used to
measure a slope or incline. The left or
right side of the laser measure serves
as the reference level for inclination
measurement.
Memory Function
The last 30 measurements are automatically stored
(can be any type of measurement: length, area, vol-
ume, etc.). To retrieve stored measurements, press
the function button 7 [Func] and use the plus button
3 [ ] or minus button 8 [ ] to cycle through the mea-
surement functions until the highlighted square ap-
pears over the indicator for memory and the word
“Memory” appears in the status bar. Select memory
by pressing the measure button 2 [
]. Use the plus
button 3 [ ] or minus button 8 [ ] to scroll through
the most recent measurements.
161'00" 5⁄32
30
If there is no value yet saved to memo-
ry, 0’00” is shown at the bottom of the
display and “0” at the top.
The oldest value is located in position
1 in the memory, while the newest
value is in position 30 (when 30 mea-
suring values have been taken). If an
additional measurement beyond the
30th measurement is taken, the oldest
value in the memory is deleted.
Deleting the Memory
To delete the measurements stored in a given memory
position, simply press the Clear/ On/Off button 5 [
]
while on the measurement you want to delete.
By simultaneously pressing the measuring reference
button 4 and the Clear/ On/Off button 5 [
], all values
stored in memory are deleted.
32.0°
To Next Page
Loading...
Need help?
General
