Bosch GLM 50 C - Adding;Subtracting Values

-32-
Adding/Subtracting Values
Adding Values
Measured or calculated values can be added or sub-
tracted.
The following example shows how to add areas:
Measure an area as described in the “Area Measure-
ment” section (page 24).
Press the plus button 3 [
]. The calculated area and
the symbol “+” are shown on the display.
Press the measure button 2 [
] to take another area
measurement. Measure an area as described in the
“Area Measurement” section (page 24). Once the sec-
ond measurement is complete, the result of the sec-
ond area measurement is shown on the result line e.
Press the measure button 2 [ ] to display the sum of
the two added area measurements.
Note: While in length measurement mode, the sum of
adding two different measurements will display imme-
diately.
To exit addition, press the function button 7 [Func].
Subtracting Values
To subtract values, press the minus button 8 [
]. The
subsequent steps are the same as for “Adding Values”.
Deleting Measured Values
Press the Clear/ On/Off button 5 [
] to delete the last
measured value in all measuring functions. Repeated
press of the Clear/ On/Off button will delete the val-
ues in reverse order.
35.908ft
2
0.0°
0.000ft
2
0.0°
0.000ft
2
L
17⁄32
12'08"
W
0'00"
0.0°
215.45ft
2
L
17⁄32
⅜
12'08"
W
16'11"