Bosch GLM 50 C - Page 23

-23-
For real time measurements, press the function button
7 [Func] and use the plus button 3 [ ] or minus button
8 [ ] to cycle through the measurement functions until
the highlighted square appears over the indicator for
real time measurement and the words “Real Time”
appear in the status bar. Select real time measurement
by pressing the measure button 2 [
]. Activate the la-
ser by pressing the measure button 2 [ ]. The laser will
be switched on and measuring will begin immediately.
2
3" ¼
76'
Watch the numbers move in real time
as you move the laser measure to-
wards or away from the object you are
aiming at.
Press the measure button 2 [
] to
hold the measurement.
Press the measure button 2 [
] to re-
activate real time measuring.
Real Time Measurement
(Small Font)
To switch to small font in real time measuring, hold
down the function button 7 [Func]. Press the plus
button 3 [
] or minus button 8 [ ] to cycle through
the menu options until the highlighted square appears
over the indicator for changing size . Press the mea-
sure button 2 [ ] and use the plus button 3 [ ] or mi-
nus button 8 [ ] to select the small font as indicated
by the . Press the measure button 2 [ ] to make
your selection and the laser measure will return to real
time measuring.
0.0°
⁄
80'06"
min
max
⁄
97'05"
97'05" 15⁄32
Watch the numbers move in real time
in result line e as you move the laser
measure towards or away from the ob-
ject you are aiming at.
Press the measure button 2 [
] to
hold the measurement.
Press the measure button 2 [
] to re-
activate real time measuring.
The maximum and minimum measurements appear in
the measured-value lines d.