Step 4. Attach Linkage
Bar/Wheel Assemblies
1. Locate the right linkage bar D/wheel
assembly G and position on right side
of upper/lower cross bar assembly A
as shown in figure 4. Note: Wheel
should face outward from stand.
2. Place one (1) flat washer L onto one
(1) bolt J and insert through right
wheel assembly G.
3. Place another (1) flat washer L on
bolt between wheel assembly G and
upper/lower cross bar assembly A.
4. Insert bolt through upper/lower cross
bar assembly A, place one (1) flat
washer L. Using two 13mm wrenches
tighten with one (1) lock nut M until
all the parts can not move freely.
Then loosen the nut by 1/8 to 1/4
turn. Note: Do not over-tighten lock
nut - these parts need to freely rotate
for stand to operate properly.
5. Repeat procedure on left side.
Step 5. Attach Kick Bar
1. Locate the kick bar C and position it
between the left and right wheel
assemblies H and G as shown in
figure 5.
2. Place one (1) star washer P onto one
(1) hex head bolt O. Insert bolt
through the wheel assembly and
thread it into the kick bar C and,
using 13mm wrench, tighten down to
the point when the star washer P
cannot move freely. Then tighten
securely by turning bolt an additional
3/4 to 1 full turn.
3. Repeat this procedure on opposite
side.
Step 6. Attach Top Tube Bar
1. Locate the top tube bar F. Position
holes in end of top tube bar F with
holes in upper cross bar A as shown
in figure 6. Make sure the plastic
bumpers FF are pointing down (Fig.
6a)!
2. Place one (1) flat washer L onto one
(1) hex head bolt J.
3. Insert bolt J through top tube bar F
and place small spacer R on bolt
between top tube bar F and upper
cross bar A.
4. Insert bolt through upper cross bar A,
place one (1) flat washer L. Using
two 13mm wrenches tighten with
one (1) lock nut M until all the parts
can not move freely. Then loosen the
nut by 1/8 to 1/4 turn. Note: Do not
over-tighten lock nut - these parts
To Next Page
Loading...
