64/68 Removal and replacement
Bosch Rexroth Mellansel AB, Installation and maintenance manual , Hägglunds CB, RE 15302-WA/05.2019
11.4 Preparing the components for storage or further use
Proceed as described in chapter 6.2.
Coupling adapter
DD00100064
1 2 3 4
Removing the coupling adapter
1. Mount the lifting eyes and secure the coupling adapter to a lifting device, see
chapter 6.1. Fig. 9
2. Mount the carriage beam to the customer shaft through the center hole of the
coupling-adapter.
3. Tighten the nut on the carriage beam against the coupling-adapter by hand.
4. Fasten the dismounting tool against the end of the coupling-adapter by using the
two screws supplied with the coupling adapter.
5. Loosen the screws on the shrink disc gradually, appr. a quarter turn each. Keep
doing this until all screws are loosened.
6. Remove the coupling-adapter from the customer shaft by turning the nut on the
mounting tool counterclockwise.
Fig. 52: Assembly tool for removing the coupling adapter
5 6
Included in coupling adapter
1. Lifting eye
Assembly tool coupling adapter
2. Dismounting tool
3. Nut
4. Washer
5. Screw
6. Carriage beam
7. Adapter M20 to M16
7
To Next Page
Loading...
