Bosch Intellic EFAS-4.10 - Tools for EFAS Error Diagnosis; Integrated Test Functions Overview

38
Workshop Manual
Smart Tachograph EFAS-4.10/4.11
8.4.1 RDI Printout of RDIs of current vehicle adjustment
The prinng of RDIs of current vehicle adjustment can only be done in calibraon mode or in the unacvated mode of the EFAS
Tachograph.
 26/04/2020 15:20 (UTC)
Time of printout
-----------------------
RDI
Type of printout
-----------

------------
Start of secon: Vehicle ID
1
 XAD1117483A
VIN (Vehicle idencaon number)
D/B-M 4711
RMS / VRN
-RDI:-
Data--------------
FD34: B1
FD3A: B1
FD00: B1
FD01: B1 B2 B3 B4
Byte 1 to byte 4
FD02: B1 B2 B3 B4
FD6E: B1
F90C: B1
F920: B1
FD26: B1 B2 B3 B4
FD9E: B1 B2
Byte 1 to byte 2
FDA3: B1
FDC6: B1 B2
FD52: B1
FD53: B1
FD69: B1 B2 B3 B4
Byte 1 to byte 8
B5 B6 B7 B8
-----------------------
DSRC - Remote Communicaon Facility
2
Status: 2 / CAN Aux.
DSRC Status / connected via CAN
Serial Number:
Serial Number
3
1234567890ABCDE
Version: 0 2.16.1 0.6.16
Hardware Version
4
Date: 04/2020
Producon Date;
-----------------------
GNSS
Fix Mode: 2
Fix Mode
5
Precision: 14
Accuracy := HDOP*10
Lat: + 52° 34.7‘
Latude
6
Lon: +013° 18.5‘
Longitude
6
------------------------
S32, S33, S34,S88, S89,
List of acve SrvIds that are important for error analysis
S176, S177, S178, S179,
S48
for the intellic support team.
1 If the data for block 4 does not exist, queson marks are printed instead of the data.
2 If there is no connecon to the DSRC module, „DSRC Facility: not available“ is printed.
3 If the serial number plus descripon is longer than one print line, the text is printed in two lines.
4 If the version plus descripon is longer than one print line, the text is printed in two lines.
5 1 -> Fix not available
2 -> 2D-Fix (< 4 SVs used)
3 -> 3D-Fix (>= 4 SVs used)
6 If FixMode =1, there is no GNSS posion aivailable. In this case, “unknown” is printed in the current seng of the local language.