Additional functions en
19
a A warning signal sounds and the
temperature display flashes be-
cause the freezer compartment is
still too warm.
2. Switch off the warning tone using
.
a goes out as soon as the set
temperature has been reached.
3. Set the required temperature.
→Page19
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ The front panels of the housing are
temporarily heated slightly. This
prevents condensation in the area
of the door seal.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
7.3 Switching off the appli-
ance
▶ Press and hold for
threeseconds.
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
▶ Press the required temperature.
To reach the set temperature, slide
the temperature controller for the
storage container to a position that
is one third from the bottom.
→Page19
The recommended temperature in
the refrigerator compartment is
4°C.
Setting the storage container
temperature
1. To reduce the temperature, slide
the temperature controller in the
direction.
2. To increase the temperature, slide
the temperature controller in the
direction.
→Fig.
10
Setting the freezer compartment
temperature
▶ Press the required temperature.
The recommended temperature in
the freezer compartment is
−18°C.
8 Additional functions
8.1 Super cooling
With Super cooling, the refrigerator
compartment cools as cold as pos-
sible.
Switch on Super cooling before pla-
cing large quantities of food.
Note:When Super cooling is
switched on, increased noise may
occur.
Switching on Super cooling
▶ Press (Refrigerator compart-
ment).
a (Refrigerator compartment)
lights up.
Note:After approx. 6hours, the ap-
pliance switches to normal operation.
Switching off Super cooling
▶ Press (Refrigerator compart-
ment).
To Next Page
Loading...
