Bosch KGN56LB41Q - 10.1 Setting up Home Connect; 10.2 Switching on the connection to the WLAN home network (Wi-Fi); 10.3 Switching off the connection to the WLAN home network (Wi-Fi); 10.4 Installing updates for the Home Connect software

en HomeConnect
22
After switching on the appliance, wait
at least 2minutes until internal
device initialisation is complete. Only
then should you set up HomeCon-
nect.
The HomeConnect app guides you
through the entire login process. Fol-
low the instructions in the HomeCon-
nect app to configure the settings.
Tips
¡ Please consult the documents sup-
plied by HomeConnect.
¡ Please also follow the instructions
in the HomeConnect app.
Notes
¡ Please note the safety precautions
in this instruction manual and
make sure that they are also ob-
served when operating the appli-
ance via the HomeConnect app.
→"Safety", Page8
¡ Operating the appliance on the ap-
pliance itself always takes priority.
During this time it is not possible
to operate the appliance using the
HomeConnect app.
10.1 Setting up HomeCon-
nect
Requirements
¡ The mobile device supports the
Bluetooth standard 4.2 or higher.
¡ The HomeConnectapp has been
installed on your mobile device.
1. Scan the QR code using the
HomeConnectapp.
RFSM0Z01
2. Follow the instructions in the
HomeConnectapp.
10.2 Switching on the con-
nection to the WLAN
home network (Wi-Fi)
▶ Press .
10.3 Switching off the con-
nection to the WLAN
home network (Wi-Fi)
▶ Press .
10.4 Installing updates for the
HomeConnectsoftware
Note:If an update of the HomeCon-
nect software is available, a message
appears in the HomeConnect app.
▶ To install the update for the
HomeConnect software, follow the
instructions in the HomeConnect
app.
a The control panel is partially
locked during the installation.
10.5 Resetting HomeConnect
settings
If your appliance experiences con-
nection problems with the WLAN
home network (Wi-Fi) or your appli-