What causes water hammer in my Bosch LV009 Heat Pump and how to fix it?
If you're experiencing water hammer with your Bosch Heat Pump, the cause may be fast closing valves. In this case, change the valves to a slow-close type.
General| Model Number | LV009 |
|---|---|
| Heating Capacity | 9, 000 BTU/h |
| Cooling Capacity | 9, 000 BTU/h |
| Refrigerant | R410A |
| Operating Temperature (Heating) | -13°F to 75°F |
| Power Supply | 208-230V, 1 Phase, 60 Hz |
| Indoor Unit Dimensions (H x W x D) | 8.3 inches |
| Outdoor Unit Dimensions (H x W x D) | 21.3" |
Explains warning symbols and keywords indicating risk levels.
Combines critical warnings for installation and operation safety.
Provides an overview of the LV series heat pump features and capabilities.
Outlines pre-installation checks for job site and unit condition.
Specifies site requirements like temperature, acoustics, and access.
Lists checks to perform before installing the unit.
Critical warnings regarding screw reuse, code compliance, and rod anchoring.
Details requirements for return air, supply air, and duct insulation.
Details requirements for condensate drain line installation, pitching, and traps.
Guidelines for piping in water and ground loop systems.
Details compliance with NEC, voltage matching, and wiring practices.
Describes the UPM board's role in compressor operation and safety monitoring.
Lists pre-startup checks for voltage, connections, and piping.
Steps for starting the unit in cooling mode and checking performance.
Steps for starting the unit in heating mode and checking performance.
Highlights the need for specialized design knowledge for closed loop systems.
Table listing common problems, causes, and solutions.
Troubleshooting steps for fan running but no compressor operation.
Troubleshooting steps for no compressor or fan operation.
Troubleshooting for PSC and constant torque motor fan operation.
Troubleshooting for airflow, mode shifting, and abnormal supply air temps.
Troubleshooting for high humidity, noise levels, and water hammer.
Covers safe decommissioning, refrigerant recovery, and waste disposal.
Sections for recording customer, unit nameplate, and operating condition data.
To Next Page
