60 | Terminology LV Heat Pump Series
LV Heat Pump Series8 733 944 336 (2016/09) Subject to change without prior notice
TERMINOLOGY
HPC-Heat Pump Controller
DDC- Digital Direct Controller
PCBA- Printed Circuit Board Assembly
LED- Light Emitted Diode
HPS- High Pressure Switch
LPS- Low Pressure Switch
NO- Normally Open
CS1/2- Compressor’s Output
ASC- Anti-short Cycle
WDT- Watch Dog Timer
HRP- Heat Recovery Package
EWT- Entering Water Temperature
DWT- Domestic Water Temperature
DRT- Discharge Refrigerant Temperature
RHS- Relative Humidity Sensor
RH- Relative Humidity
SCT-Service Configuration Tool
APP-Application
FZE-Freeze Evaporator Sensor
CFM-Cubic Feet Per Minute
PCB-Printed Circuit Board
DAT-Discharge Air Temperature
RAT-Return Air Temperature
LWT-Leaving Water Temperature
FZC-Freeze Coax Sensor
WIM-Wireless Interface Module
SSID-Service Set Identifier
QR-Quick Response
Wi-Fi-Wireless Fidelity, Wireless Internet
HP-Heat Pump
EEPROM- Electrically Erasable Programmable Read
Only Memory
Suction Pressure - Pressure entering compressor
Discharge Pressure - Pressure leaving compressor
(R/A) - Return Air
Recovery - Means the collection and storage of
fluorinated greenhouse gases from products, including
containers, and equipment during maintenance or
servicing or prior to the disposal of the products or
equipment;
Recycling- Means the reuse of a recovered fluorinated
greenhouse gas following a basic cleaning process;
Reclamation-Means the reprocessing of a recovered
fluorinated greenhouse gas in order to match the
equivalent performance of a virgin substance, taking
into account its intended use;
Decommissioning- Means the final shut-down and
removal from operation or usage of a product or piece
of equipment containing fluorinated greenhouse gases;
Repair- Means the restoration of damaged or leaking
products or equipment that contain, or whose
functioning relies upon, fluorinated greenhouse gases,
involving a part containing or designed to contain such
gases;
Conditioned space-Space within a building provided
with heated or cooled air, or both (or surfaces); and,
where required, with humidification or dehumidification
means, to maintain conditions for an acceptable
thermal environment.
To Next Page
Loading...
