Bosch Security Systems | 2006-01 | 9922 141 50701ml
UHF Wireless Microphone System | Installation and User Instructions | en | 17
Sensitivity adjusting
1 Slide down the slider of the belt-pack transmitter.
2 The sensitivity (gain) can be adjusted at the back in
the upper left corner of the belt-pack transmitter.
3 Use the supplied screwdriver to adjust the setting.
Lock mode
1 Slide down the slider around the belt-pack
transmitter.
2 Push the SET button for 3 seconds to activate the
Menu.
3 Press the SET button 1 time and use the UP and
DOWN buttons to select LOCK ON (LocON) or
LOCK OFF (Loc OFF).
4 Press the SET button to store the selected setting.
Note
In case the LOCK mode is ON, the belt-pack
transmitter cannot be switched OFF.
figure 5.4: Adjusting the sensitivity
To Next Page
