FLEXIDOME HD VR Installation | en 29
Bosch Security Systems Installation Manual AM18-Q0637 | v1.0 | 2012.12
5.7 Using the install wizard
The Menu button on the control panel is used to access the
camera install wizard. When there is a choice in the wizard, the
options are selected by either a short press (less than 2 s) or a
long press (more than 2 s) of the button.
The wizard handles the following functions:
– Lens identification
– Image orientation
– Zoom and focus adjustment conditions
–Auto focus
–Analog output
Run the wizard to select orientation and field-of-view (zoom).
Note:
The zoom and focus are adjusted again later (with the dome
bubble in place) via the web browser. This optimizes picture
sharpness in both bright and low-level lighting.
5.7.1 Adjustment procedure
If you have set up the camera and pressed the Menu button as
described in Section 5.6 Camera positioning and field-of-view,
page 26 then you see the following on the monitor screen:
– The lens type is identified and shown on the screen.
– The iris is opened to its maximum value.
Lens type: State: Focus Indicator: 0
CONTINUE
<press short>
180° ROTATE
<press long>
Timeout: 300
To Next Page
Loading...
