FlexiDome IP Configuration via the browser | en 81
Bosch Security Systems Operating Instructions V 1.0 | 2006.12
7.14 Service Settings
7.14.1 Network
The settings on this page are used to integrate the unit into an
existing network.
–Click Set after entering a new IP address.
– To do this, enter the old IP address followed by /
reset (for instance 192.168.0.80/reset) in the
address bar of your web browser. When the camera is
i
NOTICE!
Changes to the IP address, subnet mask or gateway address are
transferred to the unit by clicking Set. However, they do not
become active until the device is restarted.
To Next Page
Loading...
