Bosch Rexroth 4WS2EM 10 Series - Prior to assembly checks; Required tools for installation; Recommended accessories

Installation 25/48
RE29583-XL-B/09.20, 4WS2EM 10...XL..., BoschRexrothAG
7.4 Prior to assembly
WARNING
Explosion hazard due to wrong area of application!
A valve which is not approved for the area of application may cause an explosion!
▶ Check whether the explosion protection marks on the name plate of the valve
comply with the information in these operating instructions.
▶ Please check if you have the right valve type by means of the type designation on
the name plate of the valve.
▶ Check whether the zone assignment and the temperature class correspond to
the area of application of the valve.
▶ Check the scope of delivery for completeness and possible transportdamage.
▶ Also observe the safety instructions in chapter2.6 "Product-specific safety
instructions".
7.5 Required tools
You only require standard tools to assemble the valve.
7.6 Required accessories
The following accessories are recommended for the connection of the valve.
These accessories can be ordered separately from BoschRexroth:
Subplates with dimensions for valves with porting pattern according to
ISO4401 are listed in the "Datasheet45100".
Table 10: Flushing plate
Material number
HSA 10 B019-4X/V00-J3 R901541299
WARNING
Explosion hazard!
The test device is not approved according to the EU Explosion Protection
Directive2014/34/EU. The use of the test device in an explosive atmosphere may
cause an explosion!
▶ Only use the test device if the occurrence of an explosive atmosphere during the
test can be excluded with certainty.
Table 11: Test device
Documentation to be carried
Test device VT-SVTSY, battery-operated, can optionally be
operated with power supply unit
Datasheet29681
Subplates
Flushing plate
Test device