Contents 3/60
RE 92714-01-B/04.2018, A10VO, A10VSO, A10VSNO Series 32, Bosch Rexroth AG
1 About this documentation 5
1.1 Validity of the documentation 5
1.2 Required and supplementary documentation 5
1.3 Representation of information 6
1.3.1 Safety instructions 6
1.3.2 Symbols 7
1.3.3 Designations 8
1.3.4 Abbreviations 8
2 Safety instructions 9
2.1 About this chapter 9
2.2 Intended use 9
2.3 Improper use 9
2.4 Personnel qualifications 10
2.5 General safety instructions 11
2.6 Product-specific safety instructions 12
2.7 Personal protective equipment 14
3 General instructions regarding property and product damage 15
4 Scope of delivery 18
5 About this product 19
5.1 Performance description 19
5.2 Product description 19
5.2.1 Axial piston unit layout 19
5.2.2 Functional description 20
5.3 Product identification 21
6 Transport and storage 22
6.1 Transporting the axial piston unit 22
6.1.1 Transporting by hand 22
6.1.2 Transporting with a lifting device 23
6.2 Storing the axial piston unit 24
7 Installation 26
7.1 Unpacking 26
7.2 Installation conditions 26
7.3 Installation position 27
7.3.1 Below-reservoir installation (standard) 27
7.3.2 Inside-reservoir installation 28
7.3.3 Above-reservoir installation 30
7.4 Installing the axial piston unit 31
7.4.1 Preparation 31
7.4.2 Dimensions 31
7.4.3 General instructions 31
7.4.4 Installation with a coupling 32
7.4.5 Installation on a gearbox 33
7.4.6 Installation with cardan shaft 33
7.4.7 Remove the spacer (for version with through drive) 34
Contents
To Next Page
Loading...
