Installation 31/68
RE 92004-01-B/05.2017, A4VG Series 40, Bosch Rexroth AG
7.3 Installation position
The following installation positions are permissible. The pipeline routing shown
illustrates the basic layout.
If filling the stroking chambers via X
1
to X
4
is not possible in the final installation
position, then the filling must be effected before installation, e.g. in installation
position 2.
To prevent unexpected actuation and damage, the stroking chambers must be air
bled via the ports X
1
, X
2
, or X
3
, X
4
depending on the installation position.
For installation position 4 and 10 (drive shaft upwards), you need the additional
air bleed port R
1
in the flange area. This port is not provided in the standard
version and must be stated in plain text when ordering.
To Next Page
Loading...
