CS351 | 3609929B45/2014-09 Bosch Rexroth AG 75/108
Product description
ENGLISH
A slot interface (A)
This interface is intended for use of type A
interface modules from Rexroth.
B slot interfaces (B1, B2)
These interfaces are intended for use of
type B interface modules from Rexroth.
Slog B2 is not applicable in compact sys-
tems with integrated computer unit. The
computer unit must be configured as inter-
face module in slot B2 on commissioning.
NOTE
Damage due to improper assembly!
Damage to the connections
Carefully insert the modules, following
the assembly instructions in the mo-
dule operating instructions.
Only use interface modules from Rex-
roth.
An overview of all available inter-
face modules can be found on
the Internet at
www.boschrexroth.com/
schraubtechnik.
NOTE
Damage due to improper assembly!
Damage to the connections
Carefully insert the modules following
the assembly instructions in the mo-
dule operating instructions.
Only use interface modules from Rex-
roth.
An overview of all available inter-
face modules can be found on
the Internet at
www.boschrexroth.com/
schraubtechnik.
NOTE
Damage due to improper disassem-
bly/assembly!
Damage to the connections
The computer unit is an integral part
of the tightening system. It must not
be installed in or removed from the
Compact System subsequently like
an interface module.
CS351_zweispaltig - D.book Seite 75 Donnerstag, 2. Oktober 2014 8:36 08
To Next Page
Loading...
